Operating Your Lifebook Security/Application Panel - Fujitsu Lifebook E752 User Manual

Setting User Password
Go to the Start menu and select All Programs.
1
Select Security Panel Application and Set User Password.
2
Follow instructions to set the user password.
3
Y
OU MAY CHANGE OR REMOVE THE SUPERVISOR OR USER PASSWORD BY REPEATING THE STEPS DEFINED ABOVE

Operating Your LIFEBOOK Security/Application Panel

The security lock feature is in effect both when the system resumes from Off or suspend state. You will need to enter
the user password right after pressing the Suspend/Resume button. Your system will not begin the boot sequence
until you enter your supervisor/user password.
From Off State
Turn on your system.
1
When the Security Indicator flashes, enter the password and press [Enter] button. For example, if the password is
2
22222, press button number [2] five times and press [Enter] button. The notebook will boot to normal operation.
From Hibernate State
Press your Power/Suspend/Resume button.
1
When the Security Indicator flashes, enter the password and press [Enter] button. The notebook should resume
2
normal operation.
Incorrect Password Entry
If an invalid supervisor or user password is entered three times in succession, the system will "beep" for about one
minute. If a valid password is entered within a minute (while system beeps), the beeping will stop and the notebook
will resume normal operation. If no password (or an invalid one) is entered while the system beeps, the system will
return to its previous locked state (suspend or off) and the Security Indicator will go off. To reactivate the notebook
after a password failure, you must press the Power/Suspend/Resume button, then enter a correct password
38 - LIFEBOOK Security/Application Panel
.
.