Memory Upgrade Module; Installing Memory Upgrade Modules - Fujitsu Lifebook E752 User Manual

Memory Upgrade Module

Your Fujitsu notebook comes with high speed Double Data Rate Synchronous Dynamic RAM (DDR3-1600 SDRAM) factory
installed. To increase your memory capacity, you may install an additional memory upgrade module. The memory
upgrade must be a dual-in-line (DIMM) SDRAM module. To ensure 100% compatibility, purchase the SDRAM module
only from the Fujitsu web store at www.shopfujitsu.com
D
•
O NOT REMOVE ANY SCREWS FROM THE MEMORY UPGRADE MODULE COMPARTMENT EXCEPT THE ONES SPECIFICALLY SHOWN IN THE DIRECTIONS
FOR INSTALLING AND REMOVING THE MEMORY UPGRADE MODULE
T
•
HE MEMORY UPGRADE MODULE CAN BE SEVERELY DAMAGED BY ELECTROSTATIC DISCHARGE
THE FOLLOWING PRECAUTIONS
- B
- W
NOT TO TOUCH ANY INTERNAL TERMINALS OR COMPONENTS
- B
SLEEP STATES

Installing Memory Upgrade Modules

Turn off power to your notebook, remove any power adapter (AC or auto/airline). Remove the battery.
1
Make sure that all the connector covers are closed.
2
Turn the notebook bottom side up, and remove the screw from the memory upgrade module compartment.
3
Remove the cover.
4
Remove the memory upgrade module from the static guarded sleeve.
5
Align the memory upgrade module with the part side up. Align the connector edge of the memory upgrade
6
module with the connector slot in the compartment. Note that the memory modules will be "stacked" when both
are installed.
Insert the memory upgrade module at a 45° angle (Figure 26). Press the connector edge of the module firmly
7
down and into the connector until it lodges under the retaining clip. You'll hear a click when it is properly in place.
:
EFORE HANDLING A MEMORY MODULE
HEN INSTALLING OR REMOVING A MEMORY MODULE
E SURE TO POWER DOWN YOUR SYSTEM BEFORE ADDING OR REMOVING MEMORY MODULES
,
DATA COULD BE LOST OR THE MEMORY COULD BE DAMAGED IF POWER IS STILL AVAILABLE TO THE SYSTEM
.
.
,
TOUCH A GROUNDED METAL OBJECT TO DISCHARGE STATIC ELECTRICITY BUILT UP IN YOUR BODY
,
HOLD IT BY THE EDGE SO AS NOT TO TOUCH ANY CONTACTS OR CHIPS
;
THE OIL FROM YOUR FINGERS COULD CAUSE A SHORT TO THE COMPONENTS
75 - Memory Upgrade Module
(ESD). T
O MINIMIZE RISK TO THE MODULE
. E
VEN IF THE SYSTEM IS IN HIBERNATE OR
,
OBSERVE
.
. B
E CAREFUL
.
.