Talking Between The Phones - Sony SPP-A2480 Service Manual

3
Press Jog Dial again (or Jog Button (ENTER)).
4
Turn Jog Dial to choose "SEND DIRECTORY",
and then press Jog Dial (or Jog Button
(ENTER)).
"SENDING..." appears on the display during
the transfer.
You hear a long confirmation beep and the
entire memory is transferred.
Notes
• If there are already 50 numbers stored in the Phone Directory receiving the
transferred number one by one from the other Phone Directory, "CORDLESS
HANDSET MEMORY IS FULL." or "BASEPHONE MEMORY IS FULL."
will appear on the display and five short error beeps will be heard to indicate
that the transfer was unsuccessful. To make the transfer possible, erase one of
the stored phone numbers existing in the Phone Directory (see page 43).
• If the transfer is unsuccessful, "SEND TO CORDLESS HANDSET
FAILED." or "SEND TO BASEPHONE FAILED." will appear on the
display, and five short error beeps will be heard. Move the cordless handset
closer to the base phone, and then start over the procedure.

Talking between the phones

(Intercom)
You can talk between the base phone and the cordless handset. You
can start the intercom from either phone.
To talk from the cordless
handset to the base phone
Press (INTERCOM).
The base phone and cordless handset
ring and "** PAGING **" appears
on the display.
When a person at the base phone picks
up the handset from the base phone or
presses (SPEAKERPHONE) or
(INTERCOM), you can talk with each
other.
(OFF)
"INTERCOM" appears on the display.
(TALK)
When you are done talking
Replace the cordless handset on the
charger or press (OFF) on the cordless
handset.
If no one answers the phone
Press (INTERCOM) again.
(Cordless handset)
SEND ALL DIR?
GO BACK
NO
SEND DIRECTORY
(BASE OVERWRITE)
US
47 48
Telephone Features
continued
49 US 50
Telephone Features
– 14 –
Switching the phones during a call
You can easily switch between the cordless handset and the base
phone without disconnecting the call.
To switch from the base phone to the
cordless handset
(SPEAKERPHONE)
To switch from the cordless handset to the
base phone
(TALK)
US
Telephone Features
Talking between the phones (Intercom) (continued)
(SPEAKERPHONE)
Notes
• If there is an incoming call during intercom conversation, intercom call will
be disconnected, and both the base phone and the cordless handset will ring.
• While talking with an outside caller via the base phone or cordless handset,
you cannot make an intercom call. If you press (INTERCOM) on the cordless
handset, "BASEPHONE IN USE" appears on the display and you will hear
a busy tone.
Tip
You can receive an intercom call on the base phone or the cordless handset even
when "RINGER VOL" on the base phone is set to "OFF", or the RING switch
on the cordless handset is set to OFF. The phone will ring at a low level.
US
Telephone Features
1
Press (HOLD) on the base
phone.
The call is on hold and "HOLD"
appears on the display.
2
Pick up the cordless handset
from the charger (When Quick
talk is set to "USE"; see page 34)
or press (TALK) or (HOLD) on
the cordless handset.
You can continue talking to the
caller through the cordless
handset.
1
Press (HOLD) on the cordless
handset.
The call is on hold and "HOLD"
appears on the display.
2
Pick up the handset from the
base phone or press
(SPEAKERPHONE) or (HOLD)
on the base phone.
You can continue talking to the
caller through the base phone.
To talk from the base
phone to the cordless
handset
Press (INTERCOM).
The base phone and cordless handset
ring and "** PAGING **" appears
on the display.
When a person at the cordless handset
picks up the cordless handset from the
charger (When Quick talk is set to
"USE"; see page 34) or presses (TALK)
or (INTERCOM), you can talk with
each other.
"INTERCOM" appears on the display.
When you are done talking
Replace the handset in the cradle or
press (SPEAKERPHONE) on the base
phone.
If no one answers the phone
Press (INTERCOM) again.