Skin Detail Correction/Skin Matrix Adjustment (For Dxc-D30/D30P Only) - Sony RCP-TX7 Operating Instructions Manual

Skin Detail Correction/Skin Matrix Adjustment (for
DXC-D30/D30P Only)
The skin detail and skin matrix functions can adjust
detail level and matrix (saturation and hue) of a
selected skin gate area (area designated by color
range).
Once a skin gate area has been selected, it can be used
as a target for both skin detail correction and skin
matrix adjustment, and activation of each function can
be performed independently.
Selecting the skin gate area
Normally, use the AUTO SETUP SKIN DETAIL
button (see page 6) to designate the skin gate position
(target color) automatically.
1
Press and set the AUTO SETUP SKIN DETAIL
button to on.
The AUTO SKIN menu appears on the LCD panel,
and the window which shows the skin gate and
target area appears in the camera's viewfinder.
You can see the skin gate with a picture output
from the CCU's PIX connector.
2
Press the AUTO SETUP SKIN DETAIL button
again.
The skin gate is designated automatically.
You can manually adjust the position of the
designated skin gate in the SKIN GATE menu
(page 3/3, advanced setting page)
3
Set the size of the skin gate area (target color
range) manually using the SKIN GATE menus if
necessary.
Using page 1/3 of the AUTO SKIN or of the
SKIN GATE menu: You can adjust the R–Y
and B–Y ranges to the same value at the same
time.
Using page 2/3 of the SKIN GATE menu: You
can adjust the R–Y and B–Y ranges
independently.
Performing skin detail correction
By skin detail correction, you can lower the detail
level of the skin gate area to the detail level outside of
the area.
1
Press and set the SKIN DETAIL button to on (see
page 8).
2
Use the LEVEL knob in the SKIN DETAIL menu
to set the detail correction level.
Setting the level to the max. value (+99): The
detail level of the area is set to the lowest level.
Setting the level to the min. value (–99): The
detail level of the area is set to the same level
with the outside of the area. (The same situation
as the skin detail function is set to off.)
If you power off the unit or store the current
settings as a scene file while setting the detail level
to –99, the skin detail function will be set to off
when you power on the unit or recall the scene file
next time.
To store the skin detail settings
Set the SKIN DETAIL button on before powering off
the unit or storing the settings as a scene file. If the
button is off, the skin detail settings will not be stored.
Performing skin matrix adjustment
Follow the procedure described below to adjust the
matrix (saturation and hue) of the skin gate area.
1
Select the ON button on both pages 1/2 and 2/2 of
the MATRIX menu.
(Be sure to activate the matrix adjustment function
on page 1/2.)
2
Use the SATURATION and HUE knobs in page
2/2 of the MATRIX menu to adjust the saturation
and hue.
Selecting 00 causes the same situation as the skin
matrix function is set off.
If you power off the unit or store the current
settings as a scene file while selecting 00, the skin
matrix function will be set to off when you power
on the unit or recall the scene file next time.
To store the skin matrix settings
Activate both the matrix adjustment and skin matrix
adjustment functions before powering off the unit or
storing the settings as a scene file. Otherwise, the skin
matrix settings will not be stored.
25