Menu Contents - Sony RCP-TX7 Operating Instructions Manual

Note
The adjustment values displayed on the LCD panel
may be relative values (not real values). Slight turn of
a knob sometimes causes undesirable sudden change
of values.
Even in the case that they are real values, values may
change while they are transferred to the camera.

Menu Contents

The contents of each menu, which vary according to
the camera, are listed in the table below.
Menu title Knob/button
DETAIL FREQ knob: LL/M/H/HH
H/V knob: –99 to 00 to 99
KNEE (1/2) PRESET button
VARIABLE button
KNEE (2/2) POINT knob: –99 to 00 to 99
SLOPE knob: –99 to 00 to 99
FLARE ON/OFF buttons
RED/GREEN/BLUE knobs: –99 to 00 to
99
RECALL (1/2) SCENE F. RECALL button
See page 23 for
SEL knob: USR01 to USR16
details.
RECALL (2/2) SETUP F. RECALL button
See page 24 for
SEL knob: PRE1 to PRE5 and USR1 to
details.
USR3
STORE (1/2) SCENE F. STORE button
See page 23 for
details.
CUR knob
SEL knob: USR01 to USR16
CHR knob:
STORE (2/2) SETUP F. STORE button
See page 24 for
details.
CUR knob
SEL knob: USR1 to USR3
CHR knob:
When using the DXC-D30/D30P
The list for the case of using the DXC-637 series is on page
19.
Normal setting pages
Underlined values or settings are selected at the
shipping of the camera.
See page 17 for advanced setting pages.
Setting or operation
Boost frequency for the detail correction
Ratio of V (vertical) detail to H (horizontal) detail (As the
value becomes larger, the V detail ratio increases.)
Setting the knee point (level at which the knee correction
starts) and knee slope (amount of the knee correction)
manually using the preset values (see page 9).
Setting the knee point and knee slope manually (see page
9). Values can be set by the knob in the knee correction
block or the POINT and SLOPE knobs on page 2/2 of the
KNEE menu.
Knee point (As the value becomes larger, the start level
lowers, which enhances the knee correction effect.)
Knee slope
Select whether or not you will perform flare correction.
Amounts of flare correction for R, G and B signals.
Press to recall a scene file stored in this unit's memory.
Select a scene file that you will recall.
Press to recall a setup file stored in the camera's memory.
Select a setup file that you will recall.
Press to store a scene file onto this unit's memory. Use
the SEL knob to number the file.
Move the cursor to enter a file name (eight characters).
Select a number for the file that you will store.
Select characters to enter a file name.
Press to store a setup file onto the camera's memory. Use
the SEL knob to number the file.
Move the cursor to enter a file name (eight characters).
Select a number for the file that you will store.
Select characters to enter a file name.
(continued)
15