Table of Contents
Advertisement
UK plug wiring instructions
IMPORTANT:
Power Cable
Connections
This equipment is supplied with a mains
lead that has a non-removable moulded
plug. If the socket outlets are not suitable
for the plug supplied with this appliance,
it should be cut off and an appropriate
three-pin plug fitted.
Note: The plug severed from the mains
lead must be destroyed, as a plug with
the bared flexible cord is hazardous if
engaged in a live socket outlet.
The following wiring information should
be employed when adding the replace-
ment plug.
The wires in the mains lead are coloured
in accordance with the following code:
Green and Yellow
Blue
Brown
As the colours of the wires in the mains
lead of this appliance may not correspond
with the coloured markings identifying
the terminals in your plug, proceed as
follows.
German Acoustic Noise Regulation
Sound power level is less than 70 dB(A) according to DIN 45635 Part 19
(ISO 7779).
Die Deutsche Akustische Lärm-Regulierung
Der Grad der Klangstärke ist weniger als 70 dB (A) je nach DIN 45635
Teil 19 (ISO 7779).
CLASS 1
LASER PRODUCT TO IEC 825
LASER KLASS 1
PRODUKT NACH IEC 825
S a f e t y a n d R e g u l a t o r y N o t i c e s
The wire which is coloured green-and-
yellow must be connected to the
terminal in the plug which is marked with
the letter E, or by the earth symbol
or coloured green or green-and-yellow.
The wire which is coloured blue must be
connected to the terminal which is
marked with the letter N or coloured
black. The wire which is coloured brown
must be connected to the terminal which
is marked with the letter L or coloured
red.
Use a fuse approved to BS1362, i.e. one
which carries the
replace the fuse with one of the same
type and rating.
Always replace the fuse cover, never use
the plug with the fuse cover omitted.
Replace with same colour fuse cover only.
Replacement fuse covers may be
obtained from your dealer.
WARNING: THIS APPLIANCE
MUST BE EARTHED
Earth
Neutral
This diagram shows
Live
the wiring inside the
moulded plug. Use it
as a guideline if you
need to re-fit a plug
of a similar type to
the mains lead.
The CD-ROM drive is
classified as a CLASS 1
LASER PRODUCT. The
CLASS 1 LASER
PRODUCT label is located
on the under side of the
system unit.
or
mark. Only
ASA
E
L
N
OWNER'S HANDBOOK III
Advertisement
Table of Contents
