Table of Contents
Advertisement
Removing
There are two fastening screws for each board except the removable
media drive SCSI interface board, which has four. To remove the
backplane:
1.
Remove all disk drives from the module.
2.
Remove the fastening screws from all the boards.
3.
Push each of the boards, except the data connector board, towards
the interior of the module and manoeuvre it as necessary until it can
be freed from the framework.
4.
Lift the backplane away.
Fitting
1.
Manoeuvre the boards of the backplane through the back openings
into the interior of the framework so that they can be positioned
properly.
2.
Fasten all the boards to the module framework as shown in the
previous diagram.
S e r v i c e I n f o r m a t i o n
OWNER'S HANDBOOK 4-37
Advertisement
Table of Contents
