Wall Mounted Installations - Motorola AP 7161 Installation Manual

26

Wall Mounted Installations

For wall mounted installations, use only the access point and the angle adjust bracket sections.
The lag bolts are not included in the mounting bracket kits.
CAUTION
With the open slot connections facing down, attach the angle adjust bracket section at the desired mounting location using
1.
four #10/32 lag bolts.
Using a torque wrench or a ratchet and a 10mm socket, attach (but don't tighten) the access point bracket section to the AP
2.
7161 with four M6 hex flange screws and insert two M6 hex flange screws into the bottom holes on the sides of the access
point bracket section.
3. With the access point positioned so that the gore vent is facing down, insert the two M6 hex flange screws in the bottom holes
on the sides of the access point bracket section into the open slot connections on the bottom of the angle adapter bracket
section.
Rotate the access point bracket section upward and align the top holes on the sides with the top holes on the angle adapter
4.
bracket section. Insert two M6 hex flange screws into the top holes on the angle adapter bracket section.
Always mount the AP 7161 with the black gore vent facing down.
AP 7161 Access Point Installation Guide