Table of Contents
Advertisement
Optional settings (set as needed)
Item
Host Name
Domain Name
DNS Server
NTP Server
NTP Refresh Interval
IP Broadcast
RTSP Server
Acceptance
Multicast
Multicast Address
Memo
•
Make sure setting different IP multicast addresses to units when multiple multicast streams are used. Select the address
from "225.0.1.1" to "225.127.255.254".
•
To send multicast stream, default gateway setting is required even if there is no default gateway. In this case, set an IP
address that is not used in the network as default gateway address.
Multicast Port for
Sending
For Audio
For Video
Unicast Port for
Recieving
For Audio
For Video
API Port
Pass Through Port
for Serial 1
Pass Through Port
for Serial 2
A name for distinguishing the unit connected to a network is set.
Allowed characters are alphanumerical characters, hyphen (-) and
period (.).
Maximum number of characters allowed is 64.
Names can be set individually for a system connected with multiple
DM-NC40 units.
Allowed characters are alphanumerical characters, hyphen (-) and
period (.).
Maximum number of characters allowed is 64.
The address of the DNS server can be set.
Set when synchronizing the time of multiple DM-NC40 units.
Set interval for referencing current time to the NTP server.
[Variable: 5min, 10min, 30min, 1h, 2h, 4h, 8h, 12h, 1 day]
Set according to the used broadcast protocol.
All 1: Normally, select this setting.
All 0 (Old Protocol): Select this setting when other devices are
supporting old broadcast protocol.
Set whether to enable the RTSP server feature.
Enabled: Enables the feature. (Connection from an RTSP client is allowed.)
Disabled: Disables the feature.
How to accept communication request from other units. This setting is
valid in teleconference mode and Monitor mode.
Auto: Accepting connection automatically.
OFF: Refusing connection.
KEY: Accepting by PLAY button on the unit.
Multicast streaming is controlled.
START: Multicast transmission is started when the button is clicked.
The START button is yellow during Multicasting.
STOP: Multicast transmission is stopped when the button is clicked.
The STOP button is yellow when Multicast stream is not transmitted.
The multicast destination IP address is set.
When the START button of Multicast is clicked, multicast stream is sent
to this IP address.
The multicast destination port number is set.
When the START button of Multicast is clicked, multicast stream is sent
to this port number. Only even port numbers are allowed.
Set the port number for audio. (Setting range: 2 ~ 65534)
Set the port number for video. (Setting range: 2 ~ 65534)
The destination port number of unicast stream to receive by this unit is
displayed.
The port number for audio is displayed.
The port number for video is displayed.
The port number for API control of DM-NC40 is displayed.
The port number used by the pass-through feature of SERIAL 1 port is
displayed.
The port number used by the pass-through feature of SERIAL 2 port is
displayed.
Content
Default value
dm-nc40
network
0.0.0.0
0.0.0.0
1h (1 hour)
All 1
Enabled
KEY
STOP
225.0.1.1
50000
50002
49200
49300
23
49152
49153
31
Advertisement
Table of Contents
