Table of Contents
Advertisement
6.
Press the VIDEO SELECT button
VIDEO IN 1 and VIDEO 2 videos will switch every
time the button is pressed.
7.
Press the STOP button
Connection will be discon-
nected and the number dis-
played will be cleared.
Multicast send/receive signals (
<Camera side>
1.
Press the "START" button in Multicast of the
NETWORK SETUP screen.
3.
The ENCODE lamp and DECODE lamp will light.
Memo
When unicast communication is stopped in cam-
era side, the number display on the camera side is
off even if the unit is sending multicast stream and
some monitor side is receiving it.
When configuring remote monitoring system, set same frame rate to camera mode unit and monitor mode unit. Set bitrates
within same color on the select bar to all units.
Settings are performed in the ENCODE PARAMETERS screen for both camera mode unit and monitor mode unit ( page 32).
Monitor mode can set encode parameters for each destination camera side unit in the TELEPHONE BOOK screen.( page 34)
When settings in camera side and monitor side are different, connection may take for a few seconds because settings are
changed during connection. JPEG recording will also be unavailable during this time.
Same settings are recommended for units used for automatic alarm connection. ( page 38).
6.
7.
See page 34)
<Monitoring side>
2.
3.
Press the VIDEO SELECT button
VIDEO IN 1 and VIDEO 2 videos will switch every
time the button is pressed.
Press the STOP button
Connection will be discon-
nected and the number dis-
played will be cleared.
Enter the number that is registered for
multicast.
Press the PLAY button.
The entered number and the DECODE lamp will
light.
45
Advertisement
Table of Contents
