JVC DM-NC40 Instructions Manual page 54

Settings Using the Terminal Software of a PC
Command Table (none of the commands require arguments)
Command name
stat
set mode
set mode Camera
set mode Monitor
set mode Teleconference
set mode ISMA_Server
set mode User_Mode_xxx
set aec
set aec on
set aec off
set tcp
set tcp on
set tcp off
.set brmon start
.set brmon stop
set mode default
reboot
ctrl+c or exit
071:GET IPDISPLAY
071:SET IPDISPLAY ON
071:SET IPDISPLAY OFF
370: GET DHCPCLIENT
371: SET DHCPCLIENT ON
371:SET DHCPCLIENT OFF
For details concerning other commands, contact the nearest JVC-authorized service agent.
54
Network information, encoder information and connection information are displayed.
Available modes to select are displayed.
Camera mode is set.
Monitor mode is set.
Teleconference mode is set.
ISMA Server mode is set.
User more is set. * xxx is the mode name saved by the user.
Example: set mode User_Mode_Camera
(This command is invalid when user mode is not saved.)
Displays on/off of the echo canceller.
Default setting differs depending on the mode.
Teleconference mode: on
Monitor mode: off
Camera mode: off
ISMA Server mode: off (AEC is unavailable)
* Set to off when audio is not used. Disabling echo canceller improves video quality.
* Set to on when the echo canceller is necessary for audio communication.
Enables the echo canceller.
Disables the echo canceller.
Displays whether the transporting of audio and video stream is UDP or TCP.
Default setting is UDP. When setting to TCP, smoother audio and video playback in a
network with low reliability may be achieved.
* In the case of TCP mode, used ports are audio: 49298 and video: 49398. Port settings
in NETWORK SETUP screen are not used. In the UDP mode, used ports are audio:
49200 and video: 49300.
* In the case of RTCP, transmission will be done in UDP even when in TCP mode. When
TCP is selected, used ports for RTCP are audio: 49299 and video: 49399.
* Multicast is UDP protocol. Multicast does not turn to TCP.
Switches to TCP mode.
Switches to UDP mode.
Displays the output bitrate.
(Not available in the ISMA Server and Monitor modes)
Disables the output bitrate display.
(Not available in the ISMA Server and Monitor modes)
Initialize settings of current mode to the factory settings. * Invalid for user mode.
Restarts the unit
Quit the access by terminal software
Shows current setting of IP address display at start
Enables IP address display at start
Disables IP address display at start
Show status of DHCP
Sets to DHCP mode (enabling of this command requires the DM-NC40 to be rebooted
or the power to be turned off and turned back on.)
Set to Manual mode (enabling of this command requires the DM-NC40 to be rebooted
or the power to be turned off and turned back on.)
Operation
(Continued)