Table of Contents
Advertisement
Operating the Monitor System
For use as a Monitor system, the DM-NC40 connected to the camera side is set to the
Camera side
Camera mode and the DM-NC40 on the monitoring side is set to the Monitor mode.
Camera side
ENCODE
CF
PLAY
Number display
<Camera side> Camera mode
1.
Set the power to ON.
The number display circles, IP address is displayed as shown
on page 48, and then turns off when ready.
4.
When connection is established:
5.
Press the PinP button
44
DECODE
HOLD
IN 1
IN 2
POWER
Network
Network
STOP
HOLD SELECT
P P
in
1.
(Off)
The sent number will flash.
The display will change to a
constant display.
Video IN 1 and 2 videos will be
displayed simultaneously.
Monitoring side
ENCODE
CF
PLAY
2.
3.
Number display
<Monitoring side> Monitor mode
1.
Set the power to ON.
The number display circles, IP address is displayed as shown
on page 48, and then turns off when ready.
2.
Enter the camera-side number
• Use
• Use
the number of the selected digit (0 ~9).
Memo
• Pressing
or
first will display the number of
the previous connection.
3.
Press the PLAY button.
The entered number will flash.
4.
When connection is established:
• The display will change to a constant
• Pressing the SELECT button each time
5.
Press the PinP button
Video IN 1 and 2 videos will be
displayed simultaneously.
DECODE
HOLD
IN 1
IN 2
POWER
STOP
HOLD SELECT
P P
in
1.
(Off)
and
to select the digit to input.
and
to increment/decrement
display and the video of the camera
selected using the SELECT button is
displayed.
switches the video between VIDEO IN
1 and VIDEO IN 2.
Advertisement
Table of Contents
