Table of Contents
Advertisement
Settings Using the Terminal Software of a PC
Connection
During the power of the unit is off, connect the SERIAL 2 port of the unit to the COM port of
the PC with cross cable.
Set the Protocol select switch of Serial Port 2 to SERVICE.
Memo
Some PC may restart the unit when PC is turned on with the unit connected to PC via serial port.
Start terminal software on the PC.
Launch the terminal software using the PC.
For Windows XP:
[Start]
[Accessories]
Set the terminal software as follows:
Baud rate: 115200bps
Data length: 8 bits
Parity: None
Stop bit: 1 bit
Flow control: None
Launch screen
When the DM-NC40 is running, the prompt will appear in the terminal software when the
Enter key is pressed.
(Terminal software cannot work during Telnet is connected to the unit. Please terminate telnet
before using terminal software.)
When "dm-nc40 login:" appears on the screen, enter "nc40api" as the login name and "dmnc40"
as the password and then press the Enter key.
Enter commands while in this state.
[Communication]
[Hyper Terminal]
53
Advertisement
Table of Contents
