Table of Contents
Advertisement
Use the Installer Menu to set up, change, or view operational settings. This section describes how to
access, use, and exit the Installer Menu on location; however, you should also refer to the Installer
Menu descriptions in this document if you are configuring the STB using an FTG Configuration (.tlx)
file created using LG's FTG File Manager software.
Refer to the table on pages 27 and 28 for brief descriptions of Installer Menu items. More detailed
descriptions follow the table listing.
Accessing the Installer Menu
1. Turn ON the STB/display panel.
If the EZ-Manager Wizard appears on the screen when you turn ON the STB/display, exit the
wizard.
2. Using an Installer Remote, press MENU repeatedly until the on-screen display of the setup
menus (if the STB is in Pass-through Mode) or the Function Menu (if the STB is not in
Pass-through Mode) no longer toggles, and then press the STB Installer Menu entry sequence
(e.g., 9-8-7-6) + EXIT to access the STB Installer Menu.
Note: The default Installer Menu entry sequence is "9876"; however, if Installer Menu item 000
INSTALLER SEQUENCE has been modified, the entry sequence may be one of three additional
options. See Installer Menu detailed descriptions for further information.
The Installer Menu opens with item 000 INSTALLER SEQ 000.
STB_2000 PTC INSTALLER MENU
000 INSTALLER SEQ
UPN 000-000-000-000
PTC V1.00.020
PTC Version
Note: If the password (entry sequence) is not entered or registered correctly, you will see the message
"ENTER STB PASSWORD 0000" at the top of the screen instead of the STB Installer Menu header.
Once you re-enter the correct password (e.g., press 9-8-7-6 + EXIT), the STB Installer Menu will display.
Note: If an LG Hospitality TV (for example, LP645H, LT670H, etc.) is being used as the display panel
(connected to DISPLAY CONTROL 2 on the STB) and you press the TV Installer Menu entry sequence
+ OK, you will access the TV's Installer Menu instead of the STB's Installer Menu. The TV's Installer
Menu is accessible as read-only.
Note: If the STB is not in Pass-through Mode, the Installer Menu is accessible as read-only. Also,
the TV Zone # will be indicated in the Installer Menu header under the configuration mode indicator
described on the following page.
206-4256
CPU-CTV
000
ASIC D279
STB V3.08.00
CPU Version
Typical Installer Menu
The menu header identifies this as the
STB-2000 Installer Menu. In the Installer
Menu footer, you can see the current
software versions of the STB, as indicated.
Installer Menu
25
Advertisement
Table of Contents
