Table of Contents
Advertisement
Chapter 2 Preparations
(2)
Removal procedure
Remove the server from the rack in the following procedure.
1.
Make sure that the server is turned off and then disconnect the power cord or all interface cables
from the server.
2.
Remove the front bezel.
3.
Slowly pull the server out while
pressing the buttons located on both
side of the front of the server.
4.
Because there are stoppers, the server
will come to a stop halfway. Press and
hold Rail Stopper on the rails and pull
the server out of the rack.
5.
Hold the server firmly and remove it from the rack.
118
Important
At least two persons are required to remove the server from rack.
Important
Be careful not to get your fingers caught in the rails or lever.
Important
• While more than one person is supporting the bottom part of the server,
slowly pull out the server.
• Do not apply pressure on the server from top when it is being pulled out.
Doing so cause the server to drop.
Express5800/R120d-2M User's Guide
2. Installation and Connection
Press the button
to unlock
Rail Stopper
レールストッパー
Advertisement
Table of Contents
