Ipk Iad(8)-U( ) Configuration; Configuring Iad(8)-U( ) Etu - NEC Electra Elite IPK Installation And Maintenance Manual

C h a p t e r 4
___________________________________________________________________________________
S 1 C
ECTION ONFIGURING
When installed for the first time, the IAD(8)-U( ) ETU, comes up with factory set default
parameters as shown in
In this configuration, the ETU cannot run in any randomly given environment, and its
parameters must be redefined before the IAD(8)-U( ) ETU can work in your environment.
The required parameters can be set by using your web browser and connecting to the default
IP Address (192.168.1.100) in the browser's navigation address bar. Refer to
Setup and Configuration
S 2 PC P
ECTION
The initial configuration is performed using a PC (or laptop computer) connected to the
IAD(8)-U( ) ETU using a crossover Ethernet cable (one-to-one connection) or connecting with
a hub. Make sure that the PC has the networking parameters set as shown in
Network Settings for the
___________________________________________________________________________________
Hardware, Installation and Maintenance Manual

IPK IAD(8)-U( ) Configuration

IAD(8)-U( ) ETU
Table 4-1 Factory Network
Table 4-1 Factory Network Settings
Computer Name
IP Address
Subnet Mask
Default Gateway
for a detailed description of the Web Base Configuration.
ARAMETERS
PC.
Settings.
neciad
192.168.1.100
255.255.255.0
192.168.1.1
Appendix A
Table 4-2
4 - 1