Automatic Rerouting To Secondary Pbx - Panasonic KX-NS1000 Installation Manual

Isolated Mode Programming Procedure
Enabling Isolated Mode
The Isolated Mode setting is set to Disable by default.
Follow the procedure below to enable this setting using Web Maintenance Console.
Procedure
1.
Select the Slave unit to be programmed from the Home screen, or by using the site selection drop-down
menu.
2. Click Setup ® PBX Configuration ® Configuration ® Slot ® Site Property ® Main.
3.
Select Enable for Isolated Mode.
4.
Click OK.
Disabling Isolated Mode
You can disable the Isolated Mode setting using Web Maintenance Console.
Procedure
1.
Select the Slave unit to be programmed from the Home screen, or by using the site selection drop-down
menu.
Click Setup ® PBX Configuration ® Configuration ® Slot ® Site Property ® Main.
2.
3.
Select Disable for Isolated Mode.
4.
Click OK.
Recovering from Isolated Operation
To recover from Isolated operation, restart the Slave site using Web Maintenance Console or edit the system
data for the Isolated site.
Procedure
1.
Log in to the Isolated site using Web Maintenance Console.
2.
Right click the Isolated site on the Home screen, and then click Normal Mode.
The Isolated site will start running as a Slave unit in the One-look network.
Reference
For more information about Isolated mode, refer to "4.2.3.1 Backup Master Mode and Isolated Mode" in the
Feature Guide.
For more information about programming Isolated mode, refer to "9.5.1 PBX Configuration—[1-1]
Configuration—Slot—Site Property—Main—

Automatic Rerouting to Secondary PBX

IP terminals can switch connection from primary PBX to secondary PBX when a fault occurs to the primary
PBX.
Notice
When an IP phone connects to the PBX via a VPN using the built-in router, the IP phone cannot be rerouted
to the secondary PBX if the primary PBX fails. This is because if the PBX fails, the VPN session also fails.
Therefore, the IP phone cannot communicate with the secondary PBX at the time. In addition, when the
primary and secondary PBXs are connected to each other via a VPN using the built-in router, the same
limitation is applied.
Therefore, if automatic rerouting functionality is required for IP phones, they should be connected using
an external router instead of the built-in router.
Note
•
This feature is available for the following IP terminals.
–
KX-NT300 series and KX-NT500 series IP proprietary telephones
–
KX-UT series SIP phones (firmware update required)
–
SIP-CSs
Isolated Mode" in the PC Programming Manual.
8.4.2 One-look Networking Survivability
Installation Manual 337