Pptp Pass-Through; L2Tp Pass-Through - Panasonic KX-NS1000 Installation Manual

8.6.20 PPTP Pass-through

Description
For VPN packets that use PPTP and are sent and received from a specified device on the LAN, you can
configure settings so that (1) the port number is not changed when these packets are sent and received and
(2) these packets are allowed to cross the LAN–WAN boundary uninhibited.
Only 1 device on the LAN can be designated as the PPTP pass-through device (acting as either a server or a
client).
Setting
Application
Protocol/Protocol number
Port number
A VPN that uses PPTP is a tunnelling protocol, so the send/receive port number for packets additionally
indicates which tunnelling protocol the packets are using. If the port number is changed by the dynamic NAPT
(IP masquerade) feature, the information that indicates the tunnelling protocol will be lost, and end-to-end
communication will be impossible.
To allow end-to-end communication, specified packets from a specified device are allowed to pass through
the WAN–LAN boundary without having their port number changed.
Conditions
•
Communication across the WAN–LAN boundary is subject to the following conditions:
–
One server–client pair is limited to 1 session.
–
A PPTP-controlled connection can be established from either the LAN side or the WAN side.
–
The GRE
*1
–
You must set the LAN-side client's IP address.
*1 GRE: Generic Route Encapsulation
PC Programming Manual References
27.11 Router Configuration—VPN—[3-3] Pass Through

8.6.21 L2TP Pass-through

Description
For VPN packets that use L2TP (Layer 2 Tunnelling Protocol) and are sent and received from a specified
device on the LAN, you can configure settings so that (1) the port number is not changed when these packets
are sent and received and (2) these packets are allowed to cross the LAN–WAN boundary uninhibited.
Only 1 device on the LAN can be designated as the L2TP pass-through device (LENS
Setting
Application
Protocol/Protocol number
Port number
PPTP
GRE / 47
*1
TCP/1723: PPTP
tunnel's first packet can be sent from either the LAN side or the WAN side.
L2TP
–
UDP/1701: L2TP
Description
Description
8.6.21 L2TP Pass-through
).
*1
Installation Manual 361