Hp Procurve 530Ap - HP 800 User Manual

802.1X Quarantine Method
Setting up the 802.1X Components
HP ProCurve Access Point 420(if-ethernet)#ip address <IP of
Access Point Netmask Gateway>
HP ProCurve Access Point 420(if-ethernet)#end
HP ProCurve Access Point 420(config)#management-vlan 200
tagged
HP ProCurve Access Point 420(config)#interface wireless g
Enter Wireless configuration commands, one per line.
HP ProCurve Access Point 420(if-wireless-g)#ssid index 1
HP ProCurve Access Point 420(if-wireless-g-ssid-1)#closed-
system
HP ProCurve Access Point 420(if-wireless-g-ssid-1)#radius-
authentication-server address <IP of RADIUS Server>
HP ProCurve Access Point 420(if-wireless-g-ssid-1)#radius-
authentication-server key <Shared RADIUS secret>
HP ProCurve Access Point 420(if-wireless-g-ssid-1)#radius-
authentication-server vlan-format ascii
HP ProCurve Access Point 420(if-wireless-g-ssid-1)#ssid
Enterprise420
HP ProCurve Access Point 420(if-wireless-g-ssid-1)#vlan 100
tagged
HP ProCurve Access Point 420(if-wireless-g-ssid-1)#security-
suite 6 wpa-wpa2
HP ProCurve Access Point 420(if-wireless-g-ssid-1)#enable
HP ProCurve Access Point 420(if-wireless-g-ssid-1)#end
HP ProCurve Access Point 420(if-wireless-g)#end
HP ProCurve Access Point 420(config)#radius-accounting
address <IP of RADIUS Server>
HP ProCurve Access Point 420(config)#radius-accounting key
<Shared RADIUS secret>
HP ProCurve Access Point 420(config)#radius-accounting enable
HP ProCurve Access Point 420(config)#vlan enable dynamic
Reboot system now? <y/n>: y
Dynamic WEP: Enter the same commands as the previous configuration; how-
ever, substitute security-suite 5 instead of security-suite 6 wpa-
wpa2.

HP ProCurve 530AP

This section shows how to configure the security settings on the 530AP so that
user access may be controlled using Dynamic VLAN provisioning.
ProCurve Access Point 530#conf
ProCurve Access Point 530(config)#interface ethernet
ProCurve Access Point 530(ethernet)#ip address <IP of Access
Point > Netmask
11-53