Toshiba e-studio166 Service Handbook page 39

Procedure 6
[0][5] Code
[POWER] [Digital keys]
Procedure 7
[0][5] Code
[POWER] [Digital keys]
Procedure 17
[0][5] Code
[POWER] [Digital keys]
Note: Note:
The fuser roller temperature control at the adjustment mode is different from that at the normal
state.
Therefore, the problem of fusing efficiency may be occurred in the test copy at the adjustment
mode. In that case, turn ON the power normally, leave the equipment for approx. 3 minutes after
it has become ready state and then start up the adjustment mode again.
© 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved
Automatic
[START]
adjustment
Automatic
[START]
adjustment
Automatic
[START]
adjustment
2 - 19
06/04
Error
[FUNCTION
CLEAR]
Does not store
value in RAM [POWER]
[FUNCTION
OFF/ON
CLEAR]
Error
[CLEAR]
Stores
value in RAM
[INTERRUPT]
[POWER]
OFF/ON
Does not store
value in RAM
[FUNCTION
CLEAR]
Start
[START]
Stores
value in RAM
[INTERRUPT]
[POWER]
OFF/ON
Does not store
value in RAM
[FUNCTION
CLEAR]
Adjustment
Set manually
[25%] / [200%]
e-STUDIO163/166/203/206
ERROR CODE AND SELF-DIAGNOSTIC MODE
2