Toshiba e-studio166 Service Handbook page 82

<Test result>
Code Item
01 SRAM test
02 DRAM test
03 Image processing
RAM test
04 CODEC test
05 ADF test
06 Button test
07 LED test
08 FROM test
Notes:
1. Before the ADF test (05) is started, make sure that the equipment has no abnormality and
paper is set on the original tray.
2. When the ADF test (05) is ready to start, "0" is displayed on the 7-segment LED and the
[Start] lamp is lit. Pressing the [START] button starts the test.
3. In the button test (06), the [ENERGY SAVER] and [CLEAR] buttons are not included. (When
the [CLEAR] button is pressed during the button test (06), the display returns to the test mode
in which the code can be entered.)
4. In the LED test (07), the [ENERGY SAVER] lamp is not included.
e-STUDIO163/166/203/206
ERROR CODE AND SELF-DIAGNOSTIC MODE
Not abnormal
The following display is lit on the 7-
segment LED.
The following display is lit on the 7-
segment LED.
The following display is lit on the 7-
segment LED.
The following display is lit on the 7-
segment LED.
The number of exiting sheets is dis-
played on the 7-segment LED.
When all buttons are pressed and the
[CLEAR] button is pressed, the follow-
ing display is lit on the 7-segment
LED.
All LEDs are lit.
The following display is lit on the 7-
segment LED.
2 - 62
07/11
Result
Abnormal
The damaged memory address is dis-
played. The display can be shifted to 3
digits by the reproduction ratio button.
The damaged memory address is dis-
played. The display can be shifted to 3
digits by the reproduction ratio button.
The following display is lit on the 7-
segment LED.
The following display is lit on the 7-
segment LED.
-
When all buttons are pressed and the
[CLEAR] button is pressed, if it is not
detected that all buttons are pressed,
the following display is lit on the 7-seg-
ment LED.
The abnormal LED is not lit.
The following display is lit on the 7-
segment LED.
© 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved