Removing The Fdd - NEC FlexATX Chassis Disassembly Manual

Note
Be careful not to damage the switches and LEDs board
when pulling.
Removing the 3.5" / 5.25" Bay Assembly
To remove the 3.5" and 5.25" bay assembly first open the
chassis (see Opening the Chassis), then remove the front
panel (see Removing the Front Panel) and follow the next
steps:
1. Disconnect all data cable and power cable from the
peripherals in the bays.
2. Remove the screws as shown.
Fig. 4:
3. Slide the bays assembly towards the front of the chassis
and then lift it away carefully.
Note
Slide the 3.5/5.25-inch bracket inside the chassis taking
care that the four tabs of the chassis (two each side) fit in the four
openings of the bracket

Removing the FDD

To remove the FDD, first open the chassis (see Opening the
Chassis), then remove the front panel (see Removing the
Front Panel) and remove the 3.5" / 5.25" bay assembly (see
Removing the 3.5" / 5.25" Bay Assembly). After that, follow
the next steps:
1. Remove the screws on the bottom of the FDD.
2. Slide out the FDD from the front of the bay.
Fig. 3: Removing the front panel
Removing the 3.5" / 5.25" Bays
Disassembly and Reassembly - 4
B