Table of Contents
Advertisement
Connecting external security devices
Connect devices other than network devices (infrared sensor and warning system, etc.) to the signal input terminals on the rear
panel.
Rear input terminals
Terminal
[ALARM IN]
Name of input event:
Note:
● Set the impedance at the output end to 10kK or lower.
[WARNING
RESET]
Note:
● Set the impedance at the output end to 10kK or lower.
[OPE ON/OFF]
Note:
● Set the impedance at the output end to 10kK or lower.
● The "OPERATE OFF" works even during Operation Lock. ( A Page 114)
[REC TALLY]
[WARNING OUT]
The make contact is formed using the individual output terminals and the
[COMMON] terminal. Turning off the power of this unit switches the output of the
output terminals to break.
JVC NVR ALARM IN1 to 8 MAKE
(Generic events)
250ms or more
Make
Approx.
50ms
OPE ON
Name of input event:
JVC NVR ALARM IN1 to 8 BREAK
(Generic events)
250ms or more
250ms or more
1s or more
OPE OFF
Make Output
Make Contact Input
Break
Make Contact Input
Make Contact Input
Open collector output
(DC15V, 10 mA and
below)
(External Pull-up
Level)
Remarks
27
Advertisement
Table of Contents
