Table of Contents
Advertisement
Item
Camera (Camera Properties) (continued)
Video
Video Properties
Audio
Audio
selection
Recording
Recording
Properties
Preset Values
^
Configure Video
Properties
^
Preview
^
Default
microphone
^
Default speaker
Recording
Always
settings
Never
Conditionally
Built-in motion
Select check box
Do not select
detection
check box
Event
Select check box
Do not select
check box
^
Start event
Stop event
Configure
Hardware input
Events
events
Manual events
Generic events
^
Enable pre-
Select check box
Do not select
recording
check box
^
second(s)
Enable post-
Select check box
Do not select
recording
check box
^
second(s)
Description
Click to display the [Video Properties] screen.
Make detailed display settings for the selected camera.
Note:
● The displayed items and initial settings differ
depending on the camera. For details, see the
instruction manual of the camera.
For displaying the preview.
This setting is applicable when microphones and/or a
speaker are used. Available microphones/speakers
vary depending on the camera.
Always: Select this check box to always record images.
Never: For recording images manually without
recording settings.
Conditionally: For setting the conditions to record
images.
● Default value varies depending on the camera.
● Configure settings below when you select
[Conditionally].
Select this check box to record all images where any
motion is detected.
Select this check box to start recording at the
occurrence of an event.
● If the [Event] check box is selected, set the start
event and stop event.
Select an event and click [Open] to display the settings
screen for the selected event.
Images before/after the occurrence of motion or an
event can be recorded. You can specify units of
seconds to record before/after the occurrence.
● Default value varies depending on the camera.
93
Advertisement
Table of Contents
