NEC i-Series Gateway Quick Installation Manual page 12

$V\QFKURQRXV6HULDO 593B'LUHFW
Introduction This section of the guide provides the necessary information to configure the
i-Series Gateway for connection to an asynchronous-serial device. The units are
programmed at the factory with "default" settings providing basic parameters to
accommodate many network environments.
Figure 5. Async Connections
i - Ser i es G at eway
Punch Bl ock
PBX
C or por at e Faci l i t y
Prerequisites for Configuration
‰Ã
The i-Series Gateway (at the corporate site) and the i-Series 6000
must be installed properly and the network link between both devices must be operational.
‰Ã
The network administrator must assign an IP address for both units in order to configure and test them
over a LAN or WAN.
Basic Configuration
Table 6. Configuration Steps
You must ...
Enable the WAN port.
Set the mode (interface
type) of the WAN port.
Set the Async parameters
for the selected WAN port.
Set the Jitter Delay and
Compression settings.
i-Series Gateway 
I SD N
I SD N TA
to...
Enable WAN functions
Match the interface type
of the network device.
Match the settings for the
device being used.
Match the settings for the
device being used.
Page 12
I SD N TA
TM
Extender (at the branch office)
Default settings Refer to System
Administrator's
WAN 1 Chapter 4, Enabling
WAN Port, page 73.
V.35 Chapter 4, Setting the
Mode, page 80.
- Chapter 4, Setting
ASYNC Parameters,
page 76.
- Chapter 4, Setting Jitter
and Compression, page
79.
G-6000G-SKE, Rev AA
i - Ser i es 6000
Ext ender
Punch Bl ock
Guide