Telnet Connection; Introduction; Procedure; Html Interface - NEC i-Series Gateway Quick Installation Manual

Telnet Connection

,QWURGXFWLRQ
You can configure the i-Series Gateway using a Telnet session over the existing LAN connection. A
maximum of four Telnet connections can exist per unit at one time.
IMPORTANT:
•
You must configure all IP parameters before you can establish a Telnet session to a unit.
•
The i-Series Gateway must be powered up and online. (See Power-up procedure on page 8.)
3URFHGXUH
1. On a computer running Windows, open the Telnet application by selecting Start/Run from the
desktop.
2. Enter Telnet command along with the IP address assigned to the unit. (See below.)
Telnet address
3. Click OK.
The MI Welcome Screen is displayed. (See page 9.)

HTML Interface

Introduction

You can configure the i-Series Gateway using a standard Web server over an existing LAN connection.
This feature provides the system administrator complete management capabilities as well as status
information for both WAN and PORT connections.
IMPORTANT:
•
You must configure all IP parameters for the i-Series Gateway before the Web server session can be
established.
•
The i-Series Gateway must be connected to the LAN via the LAN port.
•
The i-Series Gateway must be powered up and online. (See Power-up procedure on page 8.)

Procedure

1. Access the MI using a Telnet session or via the Console Port.
i-Series Gateway 
Page 16 G-6000G-SKE, Rev AA