Information For The System Administrator; Installation Components; Parts Not Provided With The I-Series Gateway - NEC i-Series Gateway Quick Installation Manual

Information for the System Administrator

Once your ISDN line is installed, you will be provided with two Service Profile Identifiers (SPIDs) and two
Directory Numbers (DNs). Provide these numbers to the System Administrator.
Note: When installing the ISDN TAs, make sure you write down the SPIDs and DNs. Keep this information
in a safe place for reference. If you do not have the SPIDs or DNs, you cannot program the ISDN TAs.

Installation Components

Table 1. Installation Components
D escr i pt i on
i-Series Gateway
Universal Power Cord
DB-9 RS232 Serial Cable (6 foot)
Mounting Hardware
Mounting Brackets (2)
RS-530 type cable for high-speed links to
CSU/DSU or TA
System Administrator's Guide
Quick Installation Guide
RS-232, DB-25 to DB-9 modem cable
[male-male]. Note: This is a custom made cable.
50 pin cables with RJ-21 connectors.
Note: RJ21 cables, connecting blocks and
network cables may be ordered through NEC by
calling 1-617-454-6100.
Punch down blocks

Parts not provided with the i-Series Gateway

‰Ã
Digital telephones and communication line cords are NOT supplied with this system.
Note: Use two-wire digital telephones only.
i-Series Gateway 
Funct i on
120 VAC outlet
Console port to PC for system
administration
To attach brackets for rack mount
For rack mounting
For connecting WAN ports on i-Series
Gateway to CSU/DSU or TA
The complete guide for the i-Series
Gateway.
The condensed installation guide
For connecting the i-Series Gateway to a
modem for remote configuration.
Telephony interface between the punch
down blocks and the i-Series Gateway.
(See page 6.)
Provides the interface between the RJ-21
connector and the PBX.
Page 4
Pr ovi ded
W /
G at ew ay
9
9
9
9
9
9
9
9
Optional
Needed
but not
supplied
Needed
but not
supplied
G-6000G-SKE, Rev AA