Power-Up - NEC i-Series Gateway Quick Installation Manual

Power-Up

1. Once the VT-100 program is set up, plug the unit into an AC outlet. The device begins a series of self-
diagnostic tests, which are displayed as a series of LED flashes.
AC Power
100-240 V ~ 0.8A 50-60 HZ
Back of Unit (For a VOIP connection, see notes below.)
LAN Notes:
‰Ã
The state for the LEDs labeled XMT (Transmit), RCV (Receive), and CLN (Collision) varies depending
on the status of the network. These LEDs are not critical for verifying the "Power-up Sequence".
‰Ã
LNK LED should be solid green.
‰Ã
If you connect an i-Series Gateway to an IP network, the unit requires an assigned IP address.
‰Ã
The Ethernet port on the Gateway operates only on 10-megabit Ethernet networks. It does not support
100 megabits.
2. Once the power-up sequence is finished, the state of the following LEDs should be Green.
LED States:
PWR: Solid Green
WAN1: Solid Green (Ready) if a synchronous device is connected to WAN 1.
Solid Orange (Ready) if an asynchronous ISDN TA is connected and accepting
commands (but there is no link up- in Call Suspend mode or have not dialed it yet).
Port LEDs: Solid Green if connected properly to PBX.
IMPORTANT:
If any of the LEDs DO NOT power as explained, refer to the System
Administrator's Guide for troubleshooting information.
PWR and WAN 1
C onsol e
W AN
PW R 1
Front of Unit
On initial power-up (or before the config file has been changed) the Management Interface (MI)
displays the following prompt.
Press "Enter" to start the i-Series Gateway shell.....
Do you want to run the "Setup Wizard"
‰Ã
If you type "Yes", the wizard asks a series of configuration questions. (See page 16.)
‰Ã
If you type "NO", you enter the main MI.
3. Go to Basic Configuration on the next page.
i-Series Gateway 
TELEPHONY INTERFACE
2 3 R eset
Page 8
WAN 1
WAN 2
0
(Connected) Ports
Por t St at us
1 2 3 4 5 6 7 8 9 10 11 12
If the i-Series Gateway is powered up
prior to opening the terminal program,
this message will not appear.
LAN Connection
ANALOG LAN
LNK
XMT LNK
CLN
RCV CLN
LN K
C LN
G-6000G-SKE, Rev AA