Telephony Wiring; Vt-100 Setup - NEC i-Series Gateway Quick Installation Manual

Telephony Wiring

Table 3. Pin Assignments (25-Pair Cable)
Pin
26
1
28
3
30
5
32
7
Wire Color Abbreviations:
BK=Black, BR=Brown, RD=Red, OR=Orange, YL=Yellow, GN=Green, BL=Blue, VI=Violet, WH=White
SL=Slate

VT-100 Setup

Procedure
1. Make sure the i-Series Gateway is connected as shown on page 6.
2. You must use a communications package — for example, HyperTerminal — to configure and test the
i-Series Gateway. Attach one end of the RS-232 cable to your PC COM1 port and the other end to the
Console port connector on the front of the i-Series Gateway.
3. Set up HyperTerminal as follows:
Access: Start button > Programs > Accessories > HyperTerminal folder > HyperTerminal icon.
a
Type PBXgateway and click OK.
b
Within HyperTerminal go under File Properties and then select Connect using = Direct to COM1.
c
Select Configure and then set the parameters to 9600, 8, none, and Xon/Xoff and click OK.
d
Select the Settings tab and configure Emulation to VT100, then click OK.
e
4. Go to Power-Up sequence on the next page.
i-Series Gateway 
Cable Port Pin
Pair
WH/BL 1 34
BL/WH 9
WH/GN 2 36
GN/WH 11
WH/SL 3 38
SL/WH 13
RD/OR 4 40
OR/RD 15
Page 7
Cable Port Pin
Pair
RD/BR 5 42
BR/RD 17
BK/BL 6 44
BL/BK 19
BK/GN 7 46
GN/BK 21
BK/SL 8 48
SL/BK 23
G-6000G-SKE, Rev AA
Cable Port
Pair
YL/OR 9
OR/YL
YL/BR 10
BR/YL
VI/BL 11
BL/VI
VI/GN 12
GN/VI