Message 'Check: Punch Waste Tray - Canon imagePRESS C7000VP Series Trouble Shooting Information

2.2 Message 'Check: Punch waste tray'

 Description
There was a case where the message 'Check: Punch waste tray' persisted in the status line on
the LCD control panel even though the punch dust box was not filled with punch wastes.
 Cause
When mounting the punch chip case, the flag [2] of the punch dust box (upper) [1] failed to be in
the normal position, and thus, the punch chip case sensor (PS40) [3] failed to detect it.
 Field Remedy
When the above-mentioned symptom occurs, loosen the 6 screws that fix the punch dust box
(upper) [1], and move the box in the direction of the arrow [A] by the distance of the screw hole
play; then tighten the screw to fix the box so that the flag [2] can be detected by the punch chip
case sensor (PS40) [3].
FC6-6337 Punch Dust Box (Upper)
Trouble Shooting Information for C7000VP series
Rev. 2.0
Page 48
2010/09/17