Removing Punch Waste - Canon imagePRESS C7000VP Reference Manual

8
Gently push the saddle stitcher unit (C4) back into the
machine.
9
Close the front cover of the finisher.
CAUTION
When closing the front cover of the finisher, be careful not to get your
fingers caught, as this may result in personal injury.

Removing Punch Waste

When the punch waste tray of the optional Punch Unit-U1/W1/X1
becomes full, a screen similar to the one shown below appears on the
touch panel display. Follow the procedure described below to remove
the punch waste.
IMPORTANT
Take care when handling the optional equipment that is attached to the
machine. When an optional unit's cover is opened to replace a staple
cartridge, discard punch waste, or clear paper or staple jams, prints may
still be output if other optional units are operating normally, and are not
involved in the paper or staple jam removal procedure.
NOTE
This procedure is necessary only if the optional Punch Unit-U1/W1/X1 is
attached to the optional Finisher-AB1 or Saddle Finisher-AB2.
Finisher-AB1/Saddle Finisher-AB2/Punch Unit-U1/W1/X1 (Optional) A7-45