Loading Transparencies - Canon imagePRESS C7000VP Reference Manual

Loading Transparencies

You can load transparencies into the paper deck of the main unit,
POD Deck-A1/Secondary POD Deck-A1, Paper Deck-AC1, and Stack
Bypass-A1. Unlike normal paper, transparencies have a specific
printable surface to ensure the optimal reproduction of images.
You can load transparencies into the paper deck in the vertical
orientation shown below.
Vertical placement:
- Position the side to be printed face up (for Paper Deck-AC1 and
Stack Bypass-A1)
- Position the side to be printed face down (for other paper sources)
IMPORTANT
• Only A4, or A4R transparencies can be used.
• When loading transparencies, be careful not to touch the printable surface.
Hold transparencies by their edges.
• Fan stacks of transparencies slightly before loading. Loading
transparencies without fanning them may cause paper jams.
• Do not add more transparencies into the source while a print job is in
progress as this may cause paper jams.
• Only use transparencies that are specifically recommended for use with this
copier.Other transparencies may damage the copier.
• To prevent paper jams or the folding of transparencies, it is recommended
that you remove them from the output tray as soon as possible.
• To feed transparencies from the paper deck, you first have to designate the
paper deck as the feeding location for transparencies. (See "Identifying the
Paper Size/Type in a Paper Source," on p. A4-26.)
• Replace unused transparencies into the box they came in. Leaving them in
the paper deck for an extended period of time may cause the
transparencies to adhere to one another and result in paper jams. Avoid
storing transparencies in a place subject to high temperature or humidity.
• Leaving unused transparencies in the paper deck for an extended period of
time may cause them to adhere to one another and result in paper jams. If
this occurs, remove the transparencies and fan them slightly, reduce the
number of transparencies to 100 when more than 100 sheets of
transparencies are set, or use new transparencies.
• When printing on transparencies, image density may be high depending on
the image type. In this case, adjust the output image density.
NOTE
• You can load a maximum of 250 sheets of transparencies.
• If a paper jam occurs, remove the transparencies and fan them slightly
before reloading them into the paper deck.
• It is recommended that transparencies which are printed in the Full Color
mode be used with transparent type overhead projectors. Transparencies
may appear dark with reflective type overhead projectors.
Paper Decks A7-11