Limiting Functions - Canon imagePRESS C7000VP Reference Manual

Limiting Functions

If a problem frequently occurs when using the Finishing modes, such
as Offset Collate and Staple, you can temporarily limit the use of
these finishing modes by setting Limited Functions Mode to 'On'.
In addition, when the Service Call Message screen appears indicating
a finishing mode malfunction and you temporally set the Limited
Functions Mode to clear the Service Call Message screen, you can
deactivate the Limited Functions Mode by setting this mode to 'Off'
from the Additional Functions screen. However, after the Limited
Functions Mode is deactivated, the Service Call Message screen may
appear again, unless the cause of the malfunction is cleared. (See
"Setting the Limited Functions Mode from the Service Call Message
Screen," on p. A8-127.)
IMPORTANT
[Limited Functions Mode] is displayed only if the optional Finisher-AB1,
Saddle Finisher-AB2, Perfect Binder-B1, or High Capacity Stacker-C1 is
attached to the machine.
1
➞ [Common Settings] ➞ [Limited Functions
Press
Mode].
2
Select the finishing mode you want to limit.
3
Select [On] or [Off] ➞ press [OK].
NOTE
The Limited Functions Mode is enabled only after you restart the machine
(the main power is turned OFF, and then back ON). For instructions on
restarting (turning the main power OFF, and then back ON) the machine,
see "Main Power and Control Panel Power," on p. A1-7.
Specifying Common Settings A4-49