Roller Cleaning
If dirt or streaks appear on printed output, clean the roller inside of the
main unit.
NOTE
It takes approximately one minute to clean the roller.
1
➞ [Adjustment/Cleaning] ➞ [Roller Cleaning].
Press
2
Press [Start].
When cleaning is complete, try printing again.
Size Change Plate Width Adjustment
When using special types of paper, such as coated paper, the paper
size may be slightly different from the standard paper sizes, and this
may cause the problems. Adjusting the width between the size
change plates can solve the following problems due to the paper size.
■ If the paper size is larger than a standard paper size:
Paper jams may occur if the space between the size change plates
and the paper is too narrow. Make the space between the size
change plates and the paper wider.
■ If the paper size is smaller than a standard paper size:
The entire printed area may be shifted vertically to the top or
bottom, or may be slanted if the space between the size change
plates and the paper is too wide. In this case, make the space
between the size change plates and the paper narrower.
Direction of Paper Being Transported
Normal
NOTE
[Paper Deck Plate Adjustment] appears only if the optional Paper
Deck-AC1 is attached.
Shifted
Slanted
Adjusting the Machine
A4-71