Density Adjustment Mode - Canon imagePRESS C7000VP Reference Manual

1
➞ [System Settings] ➞ [Device Management
Press
Settings] ➞ [Exposure Recalibration when Scanning].
2
Press [-] or [+] under <Left Edge> or <Right Edge> to set
the exposure recalibration.
Details of each item are shown below.
0: This is the default value. Exposure recalibration is not made when
scanning originals.
1 to 5: Exposure recalibrations are made when scanning originals. Increase
the value to increase the exposure recalibration level.
NOTE
You can set the value for <Left Edge> and <Right Edge> separately. For
example, if you want to perform a full-scale recalibration for the left edge,
but only a slight calibration for the right edge, set '5' for <Left Edge> and '1'
for <Right Edge>.
3
Press [OK].

Density Adjustment Mode

This mode enables you to change the method to control the amount of
toner.
■ A Mode
This is the default setting. The amount of toner is restricted in this
mode, and settings made for colour adjustments, such as Color
Balance, may not be reflected to prevent the toner on the paper
from scattering and image blurring on high density areas.
■ B Mode
This mode removes all toner restrictions. Settings made for colour
adjustments, such as Color Balance, are directly reflected.
IMPORTANT
[Density Adjustment Mode] is displayed only when the settings are made
available by your local authorized Canon dealer. Even if [Density
Adjustment Mode] is displayed, do not allow anyone to change the settings
except for the system manager. For more information on changing the
settings, contact your local authorized Canon dealer.
Device Management Settings A6-76