Demo Mode; Setting Demo Mode; Exiting Demo Mode - Electrolux Washing machine Service Manual

8 DEMO Mode

A special cycle has been created for demonstration of the operation of these appliances in retail outlets
without connecting the appliance to the water supply. In this way, the salesman can select any programme;
after starting the cycle by pressing START, the appliance will perform certain phases only, and will skip
those which cannot be performed (water fill, drain, heating).
The cycle takes place as follows:
the door locking device is actioned in the normal way (i.e. the door remains locked while the appliance
is in operation, and can be opened at the end of the cycle or in pause mode)
motor: all low-speed movements are enabled, while the pulse signals and the spin cycle are excluded
the water fill solenoids and the drain pump are disabled
display: since the phases of the cycle take place in rapid succession (1 second of the demo cycle is
equivalent to 1 minute of the actual cycle), the time-to-elapse decreases by 1 unit per second.
Remember that the time-to-elapse does not always correspond to the actual cycle time
alarms: for reasons of safety, the following groups of alarms remain enabled: E40 (door closed), E50
and E90 (communication between the boards/configuration).

8.1 Setting Demo mode

1. Cancel the current programme and switch the appliance off.
2. Press the FABRICS (1) and SPIN (3) buttons simultaneously and then, holding the buttons down,
switch the appliance on using the ON/OFF button.
3. Hold the buttons down for at least 2 seconds within 5 seconds.

8.2 Exiting demo mode

To exit demo mode, switch the appliance off.
SOI/DT 2005-07 dmm 46/59 599 37 22-15