HP 100B Maintenance & Serice Manual page 58

4. Remove the tape (3) that secures the cable to the computer, and then lift the cable from the
computer.
Figure 6-33
5. Remove the webcam module cable from the computer.
To remove the webcam module:
1. Prepare the computer for disassembly (see
on page
2. Remove the rear cover (see
3. Remove the three Phillips PM20x30 screws (1) that secure the webcam module assembly to the
computer.
4. Lift the webcam assembly up as much as the cable allows (2), and then disconnect the cable
from the module (3).
Figure 6-34
5. Remove the webcam module assembly from the computer.
50 Chapter 6 Removal and Replacement Procedures All-in One (AIO) Chassis
Removing the webcam module cable
26).
Rear Cover on page
Removing the webcam module
Preparing to Disassemble the Computer
27).