Surface Controls Cooking; Pf Or Hs Message; Locations Of The Radiant Surface Elements And Controls - LG LRE30451SW Owner's Manual & Cooking Manual

CAUTION
BEFORE SURFACE COOK
• Do not use the glass cooktop surface as a cutting board.
• Do not place or store items that can melt or catch fire on
the glass cooktop, even when it is not being used.
• Always turn the surface units on after placing cookware.
• Do not store heavy items above the cooktop surface that
could fall and damage it.
DURING SURFACE COOK
• Do not place aluminum foil or plastic items such as salt
and pepper shakers, spoon holders, or plastic wrappings
on the range when it is in use. The hot air from the vent
could melt plastics or ignite flammable items
• Make sure you turned on the correct surface unit.
• Never cook directly on the glass. Always use cookware.
• Always place the pan in the center of the surface unit
you are cooking on.
• Never leave surface units unattended at high heat
setting. Boilovers cause smoking and greasy spillovers
that may catch on fire.
• Always turn the surface units off before removing
cookware.
• Do not use plastic wrap to cover food. Plastic may melt
onto the surface and be very difficult to remove.
AFTER SURFACE COOK
• Do not touch surface units until it has cooled down.
• The surface elements may still be hot and burns may
occur if the glass surface is touched before it has cooled
down sufficiently.
• Immediately clean the spills on cooking area to prevent
a tough cleaning chore later.
• If cabinet storage is provided directly above cooking
surface, limit it to items that are infrequently used and
can be safely stored in an area subjected to heat.
Temperatures may be unsafe for items such as volatile
liquids, cleaners or aerosol sprays.
PF
(Power Failure) MESSAGE
The PF message will appear whenever there has been a
power interruption to the appliance. To clear the PF message
press ON/OFF control pad to reset and be sure to reset the
clock with the correct time of day.

SURFACE CONTROLS COOKING

HS
( Hot Surface) MESSAGE
LIGHT WILL:
• Come on when the unit is hot to touch after it is turned off.
• Come on during Self Cleaning Cycle.
• Stay on even after the unit is turned off.
• Glow until the unit has cooled down to approximately 150°F.
LOCATIONS OF THE RADIANT
SURFACE ELEMENTS AND
CONTROLS
The radiant surface elements are located on the cooktop as
below.
The radiant control key locations are correlative to radiant
surface elements on the cooktop as shown below.
Single
Left Rear Element
Dual
Left Front
Dual Element
- 6 -
Single
Right Rear Element
Warming Zone
Single
Right Front Element