Brother MFC-J5520DW User Manual page 62

Error Message
(MFC-J5520DW/J5620DW)
Current Tray #1
Settings
Current MP Tray
Settings
(MFC-J5720DW)
Current Tray #1
Settings
Current Tray #2
Settings
Current MP Tray
Settings
Data Remaining in
Memory
Disconnected
Document Jam/too Long The document was not inserted or fed
DR Mode in Use
High Temperature
Hub is Unusable.
Image Too Long
Image Too Small
50
Cause
These messages are displayed when
the Check Paper setting to confirm
the paper type and size is enabled.
Print data is left in the machine's
memory.
The other person or other person's
fax machine stopped the call.
correctly, or the document scanned
from the ADF was too long.
The machine is in Distinctive Ring
mode. You cannot change the
Receive Mode from Manual to
another mode.
The room temperature is too high.
A hub or USB flash drive with hub has
been connected to the USB direct
interface.
The proportions of your photo are
irregular so effects could not be
added.
The size of your photo is too small to
trim.
Action
To not display this confirmation
message, set the Check Paper
setting to Off. (See Check Paper
setting on page 23.)
Press . The machine will cancel
the job and clear it from the memory.
Try to print again.
Try to send or receive again.
If calls are stopped repeatedly and
you are using a VoIP (Voice over IP)
system, try changing the
Compatibility to Basic(for VoIP).
(See Telephone Line Interference or
VoIP System on page 77.)
(See Using the ADF on page 24.)
(See Document jam on page 58.)
Set Distinctive Ring to Off.
(See Online User's Guide: Register
the Distinctive Ring Pattern.)
After cooling the room, allow the
machine to cool down to room
temperature. Try again when the
machine has cooled down.
Hubs, including a USB flash drive that
has a built-in hub, are not supported.
Unplug the device from the USB
direct interface.
Choose a regularly proportioned
image.
Choose a larger image.