Turning The Power On - NEC Storage M700 Setup Manual

６

Turning the Power On

Power up the system, referring to the following section:
"NEC Storage M700 Disk Array Unit User's Guide", 1-3-1 Powering on the Disk Array System
７
Installing and Setting Up the Software
Install the software required to prepare and set up the iSM client.
7-1
Preparation
Prepare the client machine on which the iSM client will be used. See the following section:
"NEC Storage M700 Disk Array Unit User's Guide", 4-2 Before Starting NEC Storage Manager Client
7-2
Specifying the IP address
Install the network setup tool and then specify the IP address for the disk array. See the following sections:
"NEC Storage M700 Disk Array Unit User's Guide", 4-3-1 Installing the Network Setting Tool
"NEC Storage M700 Disk Array Unit User's Guide", 4-3-2 Configuring IP Addresses by Using Network Setting Tool
"NEC Storage M700 Disk Array Unit User's Guide", 4-3-3 Setting a Time Zone of the Disk Array
7-3
Installing NEC Storage Manager Agent Utility
Install NEC Storage Manager Agent Utility on the application server. See the following section:
"NEC Storage M700 Disk Array Unit User's Guide", 4-4 Installing NEC Storage Manager Agent Utility on the Application Server
7-4
Starting iSM client
Start the iSM client on the client machine. See the following section:
"NEC Storage M700 Disk Array Unit User's Guide", 4-5 Starting NEC Storage Manager Client
"NEC Storage M700 Disk Array Unit User's Guide", 1-3 Basic Operation
"NEC Storage M700 Disk Array Unit User's Guide", Chapter 4, NEC Storage Manager