Sony HDC-X300 Operation Manual page 30

01: FUNCTION 1 SLS [F]
(cont.)
02: FUNCTION 2 IRIS OVERRIDE
D5600
EVS
SCAN MODE
STILL MODE
03: TLCS AGC
AGC LIMIT
AGC CHANGE
POINT
AE
AE LIMIT
AE CHANGE POINT F5.6/F8/F11/
AUTO ND
ND CENTER
POINT
30
Menu Operations
[2]
/3/4/5/6/7/8/16/32/64
[0]
–1/ –0.5/ /0.5/1
[OFF]
ON/
[OFF]
ON/
[60I]
/30PsF/24P
[50I]
/25PsF
[OFF]
ON/
[OFF]
ON/
[12]
3/6/9/ /15/18/ dB
[F2.8]
OPEN/F2/
[OFF]
ON/
1/100, 1/150, 1/200,
[1/250]
, 1/500, 1/1000,
1/2000, 1/4000, 1/10000
1)
[OFF]
ON/
[F5.6]
F4/ /F8
1)
To select the number of accumulating frames
of the slow shutter when you set SHUTTER
MODE to SLS
To select the reference value for the iris
To turn the function that electrically applies a
5600K color temperature filter on/off
To turn the EVS function that increases the
vertical resolution on/off
To set the scan mode to 60I, 30PsF or 24P
To set the scan mode to 50I or 25PsF
To turn Still mode on/off
Note
If a lens that does not return the iris value
signal is used, the iris is fixed to the open end
when the IRIS switch of the lens is set to A
(Auto) in Still mode.
To turn the automatic gain adjustment on/off
(With AGC ON, the unit maintains the
luminance at a certain level by automatically
adjusting the gain in the range up to the AGC
LIMIT value when the iris setting becomes
wider (toward OPEN) than the AGC CHANGE
POINT setting.)
To select the maximum gain value of the
automatic gain adjustment
/F4/F5.6 To select the iris value at which the unit is
switched from Auto iris mode to Automatic
Gain Adjustment mode
To turn the automatic shutter adjustment on/
off
(With AE ON, the unit maintains the
luminance at a certain level by automatically
adjusting the shutter speed in the range up to
the AE LIMIT value when the iris setting
becomes narrower than the AE CHANGE
POINT setting.)
To select the minimum shutter speed of the
automatic shutter adjustment
[F16]
To select the iris value at which the unit is
switched from Auto iris mode to Automatic
Shutter Adjustment mode
To turn the auto ND filter function on/off
(With AUTO ND ON, the unit maintains the
luminance at a certain level by automatically
switching the ND filters so that the iris is set in
the range of ±2 steps from the ND CENTER
POINT setting. Note that this ND filter
switching will not occur when the tally lamp is
lit.)
To select the center iris value to be the target
of the auto ND filter function
S
A
S R A
S R A
S
S
A
A
A
A
A
A
A
A