Pioneer AVIC-8100NEX Operation Manual page 230

Appendix
Appendix
Message
Detected unusual speed
pulses.
Detected changes in the in-
stallation angle or position.
The in-dash receiver is updat-
ing the sensor learning data.
Speed pulse wire is not con-
nected. The system will oper-
ate in simple hybrid mode.
Pandora
Message
Communication error oc-
curred.
Error-19
Skip limit reached.
Check Device
Incompatible USB
Check USB
Aha Radio
Message
Communication Error
Error-02-6X
230
En
Cause
The speed pulse cannot be detected
correctly.
Changes in the installation angle or
position are detected.
Speed pulse wire is not connected.
Cause
iPod failure.
Communication failed.
Skip limit reached.
Device error message displayed in
Pandora application.
The connected USB storage device
is not supported by this product.
The USB connector or USB cable
has short-circuited.
The connected USB storage device
consumes more than maximum al-
lowable current.
Cause
iPod failure.
iPod failure.
Action
Contact your dealer or an authorized Pioneer
Station for assistance.
Wait until the sensor learning finishes.
The speed pulse cannot be detected if the
speed pulse wire is not connected correctly.
Action
Disconnect the cable from the iPod. Once the
iPod's main menu is displayed, reconnect the
iPod and reset it.
Disconnect the cable from the iPod. Once the
iPod's main menu is displayed, reconnect the
iPod and reset it.
! Do not exceed the skip limit.
! Due to music licensing restrictions,
Pandora limits the total number of skips per
hour.
Please check your connected device.
Disconnect your device and replace it with a
compatible USB storage device.
Check that the USB connector or USB cable
is not caught in something or damaged.
Disconnect the USB storage device and do
not use it. Turn the ignition switch to OFF,
then to ACC or ON and then connect a com-
pliant USB storage device.
Action
Disconnect the cable from the iPod. Once the
iPod's main menu is displayed, reconnect the
iPod and reset it.
Disconnect the cable from the iPod. Once the
iPod's main menu is displayed, reconnect the
iPod and reset it.