Blade Spindle - Toro Groundsmaster 3505-D Service Manual

Blade Spindle

RIGHT
FRONT
1. Socket head screw (2 per motor)
2. Flat washer (2 per motor)
3. Hydraulic deck motor
4. O- -ring
Removal (Fig. 13)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Remove two (2) socket head screws and flat wash-
ers that secure hydraulic motor to the cutting unit (Fig.
14). Remove hydraulic motor from deck. Locate and re-
trieve o--ring from top of spindle housing.
3. Cover top of spindle to prevent contamination.
Spindle plug (Toro Part # 94--2703) can be used to cover
spindle.
Cutting Units
5
6
7
8
9
10
Figure 13
5. Flange nut (6 used)
6. Spindle plate
7. Cutting deck
8. Spindle assembly
Page 7 - - 12
1
2
3
4
11
12
9. Cap screw (6 used)
10. Cutting blade
11. Anti- -scalp cup
12. Blade bolt
4. Start the engine and raise the cutting unit. Stop en-
gine and remove key from the ignition switch. Support
the cutting unit so it cannot lower accidentally. If required
for easier service, remove cutting unit from machine
(see Cutting Unit Operator's Manual).
5. Remove cutting blade bolt, anti--scalp cup and cut-
ting blade (see Cutting Unit Operator's Manual).
6. Remove six (6) cap screws and flange nuts securing
spindle housing to deck. Lower spindle assembly out
the bottom of the deck. Remove spindle plate from top
of deck.
Rev. A
88 to 108 ft- -lb
(119 to 146 N- -m)
Groundsmaster 3505--D