Removal - Toro Groundsmaster 3505-D Service Manual

Engine
15
12
11
2
5
9
6
13
41
40
10
1. Kubota engine
2. Engine mount (2 used)
3. Engine mount
4. Flange nut (6 used)
5. Cap screw (3 used)
6. Flange head screw (6 used)
7. External lock washer
8. Lock nut (3 used)
9. Hardened washer (3 used)
10. Machine screw
11. Hardened washer (11 used)
12. Cap screw (5 used)
13. Engine mounting bracket (front)
14. Engine mounting bracket (LH)
Removal (Fig. 7)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Open and remove hood from the machine (see Trac-
tion Unit Operator's Manual). Slide operator seat all the
way forward.
3. Disconnect air hose from the air cleaner and radiator.
Remove air cleaner from the engine (see Air Cleaner
Assembly Removal in this section).
Kubota Diesel Engine
27
37
21
36
32
34
35
17
18
31
20
3
4
12 11
11
15. Engine mounting bracket (RH)
16. Cap screw (4 used)
17. Pulley
18. Bolt (3 used)
19. Flange nut (2 used)
20. Flat washer (3 used)
21. Exhaust gasket
22. Throttle swivel
23. Lock nut
24. Slotted hex head screw
25. Throttle cable clamp
26. Cap screw
27. Radiator hose (lower)
28. Lock nut
1
29
33
39
30 16
14
6
2
9
8
Figure 7
4. Disconnect both battery cables at the battery (see
Battery Service in Chapter 5 -- Electrical System).
5. Remove muffler from the exhaust manifold and muf-
fler bracket (see Muffler Removal in this section).
6. Drain coolant from the radiator into a suitable con-
tainer (see Radiator Removal in this section). Discon-
nect radiator hoses from the water pump and engine
block.
Page 3 - - 12
37
23
42
22
24
28
25
26
19
5
11
16
7
4
29. Lock washer
30. Flat washer
31. Flange head screw (2 used)
32. Flat washer
33. R- -clamp
34. Lock washer
35. Hex nut
36. Wire harness
37. Hose clamp
38. Radiator hose (upper)
39. Wire harness ground
40. Pump mount plate
41. Spacer
42. Throttle support bracket
Groundsmaster 3505--D
38