Toro Groundsmaster 3505-D Service Manual page 99

Removal (Fig. 43)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch.
NOTE: The ports on the manifold are marked for easy
identification of components. Example: BV is the deck
circuit braking valve and P1 is the gear pump connection
port (see Hydraulic Schematic to identify the function of
the hydraulic lines and cartridge valves at each port
location).
2. Thoroughly clean hydraulic manifold before doing
any disassembly.
WARNING
Before disconnecting or performing any work
on the hydraulic system, all pressure in the
system must be relieved. See Relieving Hy-
draulic System Pressure in the General Infor-
mation section.
3. Label all hydraulic hoses and fittings for assembly
purposes. Also, mark fittings to allow correct assembly
orientation.
4. Remove hydraulic manifold from the machine using
Figure 43 as guide.
Groundsmaster 3505--D
Installation (Fig. 43)
1. Install hydraulic manifold to the frame using Figure
43 as guide. Use labels and marks made during the re-
moval process to properly install hoses and fittings.
2. Make sure hydraulic tank is full. Add correct oil if nec-
essary (see Traction Unit Operator's Manual).
Page 4 - - 69 Hydraulic System