Toro Groundsmaster 3505-D Service Manual page 85

Hydraulic Tank Removal (Fig. 33)
1. Drain hydraulic oil from Hydraulic tank (see Traction
Unit Operator's Manual).
2. Thoroughly clean hydraulic hose ends and fittings on
hydraulic tank to prevent hydraulic system contamina-
tion.
3. Remove hydraulic tank using Figure 33 as a guide.
Discard and replace any o--rings that are removed.
Hydraulic Tank Inspection (Fig. 33)
1. Clean hydraulic tank and suction strainer with sol-
vent.
2. Inspect hydraulic tank for leaks, cracks or other dam-
age.
Hydraulic Tank Installation (Fig. 33)
1. Apply antiseize lubricant to the four (4) flange head
screws that secure the hydraulic tank to the frame.
2. Position hydraulic tank to machine. Secure tank to
frame with four (4) flange head screws, flat washers and
grommets. Torque screws from 30 to 60 in--lb (3.4 to 6.8
N--m).
Groundsmaster 3505--D
3. Attach fittings with new o--rings and hoses to hydrau-
lic tank using Figure 33 as a guide.
4. Thread suction strainer into hydraulic tank.
5. Using a wrench, turn strainer into tank port 1--1/2 to
2 full turns beyond finger tight.
6. Fill hydraulic tank with new hydraulic fluid (see Trac-
tion Unit Operator's Manual).
7. Operate machine. Check hydraulic oil level and ad-
just if necessary. Check hydraulic components for leaks.
Tighten any loose connections.
Page 4 - - 55 Hydraulic System