Programming The End Receiving Station Into Your Auto Dialer - Panasonic Workio DP-190 Operating Instructions Manual
Digital imaging system
for facsimile and internet fax/email
Hide thumbs
Also See for Workio DP-190:
- Operating instructions manual (66 pages) ,
- Service handbook (188 pages) ,
- Service manual (375 pages)
Table of Contents
Advertisement
Programming the End Receiving Station into your Auto Dialer
If the Fax Parameter No. 140
(LAN Relay XMT Request)
is set to "Valid", you can
enter the Relay Address by
the following procedure.
To set an One-Touch/ABBR
Dialing for Relayed
Transmission Request
5
<01>
ENTER TEL. NO.
Enter the telephone number (up to 36 digits).
If the Relay and the End Receiving Stations are both in the same
area, omit the Country Code and the Area Code from the End
Receiving Station. The End Receiving Station is a local telephone
number as viewed from the Relay Station.
120
Advanced Internet Fax Features
Relayed Transmission
1
Ex: 3961111234 and
press
SET
2
6
<01>ENTER NAME
3961111234
Ex: ROME and
press
SET
Enter the station name
(up to 15 characters)
by using the keypad
Advertisement
Table of Contents
