Verification Stamp And Flash Memory Card; Verification Stamp; Installing The Flash Memory Card - Panasonic Workio DP-190 Operating Instructions Manual

Verification Stamp

The Verification Stamp contains ink. When the stamp mark appears faded or hard to see, the stamp should be replaced or
refilled with ink.
To remove the stamp
1
Lift the ADF.
4

Installing the Flash Memory Card

Before installing, make sure that there is no document file(s) stored in the memory. You may confirm by printing out a File
List (see page 98). When the memory card is installed, the machine will initialize the document memory, all contents
stored in the document memory at that time will be lost.
1
(1) Turn the Power Switch OFF and
unplug the Power Cord.
(2) Remove the Memory Card
Cover.
NOTE
176
Problem Solving

Verification Stamp and Flash Memory Card

Remove the Stamp. Replace the stamp with a new one or
refill the stamp with a few drops of the specified ink into
the back of the stamp.
1. Please contact your local Authorized Panasonic Dealer to purchase a new stamp.
2. Stamp ink refills can be purchased from a stationary store. Use blue Shachihata "X" Stamp ink
(No. 22113) or its equivalent.
2
Detach the Scanning Pad from the
left side only.
Verification Stamp Order No.: DZHT000027
2
(1) Insert the Flash Memory Card gently into the card
slot with the Panasonic logo facing towards the
inside of the machine.
Caution : Installing the Memory Card in the wrong
direction may damage the connecting
pins inside the machine.
(2) Reinstall the Memory Card Cover.