Toro Groundsmaster
4000?D Service Manual page 31

PRELIMINARY – For Toro Distributor and Toro Company use only.
shroud.
8. Connect throttle cable to the speed control lever with
washer and lock nut. Install cable to mounting bracket
(Fig. 11). Adjust throttle cable.
9. Connect fuel line to the injection pump (Fig. 11).
10.Install traction cylinder assembly to engine adapter
plate.
IMPORTANT: Support hydraulic pump assembly to
prevent it from falling and being damaged.
11. Install hydraulic pump assembly to engine (see
Pump Assembly in Chapter 4 − Hydraulic Systems).
12.Connect two (2) wires to neutral switch on traction
pump.
13.Connect wires and/or electrical connections to the
following electrical components:
A. The temperature sender and alternator (Fig 10).
B. The engine run solenoid and fuel pump (Fig. 12).
C. The high temperature shutdown switch and glow
plug (Fig. 13).
D. Battery, frame and wire harness ground to the en-
gine block (Fig. 14).
E. The starter (Fig. 14) and low oil pressure switch
(near starter).
Groundsmaster 4000−D
14.Install air cleaner assembly to the engine (see Air
Cleaner Installation in this section).
15.Install exhaust system to machine (see Muffler
Installation in this section).
16.Connect coolant hoses to the radiator. Make sure ra-
diator drain is shut. Fill radiator and reservoir with cool-
ant.
17.Check position of wires, fuel lines, hydraulic hoses
and cables for proper clearance with rotating, high tem-
perature and moving components.
18.Position battery to machine. Connect positive bat-
tery cable first and then negative battery cable. Secure
battery to machine with strap and cover.
19.Check and adjust engine oil as needed.
20.Check and adjust hydraulic oil as needed.
21.Bleed fuel system.
22.Operate hydraulic controls to properly fill hydraulic
system (see Charge Hydraulic System in Chapter 4 −
Hydraulic Systems).
Page 3 − 15 Kubota Diesel Engine