Toro Groundsmaster
4000?D Service Manual page 93

PRELIMINARY – For Toro Distributor and Toro Company use only.
Removal (Fig. 40)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch.
2. To prevent contamination of hydraulic system during
removal, thoroughly clean exterior of pump assembly.
3. Remove traction rod from control arm on piston
pump by removing lock nut, spacer and cap screw.
4. Disconnect two (2) wires from neutral switch on trac-
tion pump.
5. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
6. For installation purposes, label all hydraulic lines that
connect to gear pump and piston pump.
7. Put a drain pan below the pump assembly. Remove
hydraulic hoses and fittings connected to piston and
gear pumps. Put plugs or caps on disconnected hydrau-
lic hoses to prevent contamination of the system. Put
plugs in open ports of pumps.
8. Remove gear pump from machine (see Gear Pump
Removal in this section). Note: If fuel tank is loosened
and raised from the machine, the gear pump and piston
pump can be removed as a complete assembly.
9. Support the piston pump to prevent it from falling
while removing two (2) cap screws and washers retain-
ing pump assembly to engine flywheel plate. Carefully
pull pump assembly from flywheel plate and raise it out
of the machine.
Groundsmaster 4000−D
Installation (Fig. 40)
1. Carefully lower piston pump into the machine, align
pump input shaft to spring coupler on engine and posi-
tion it to the engine flywheel plate. Support pump to pre-
vent it from producing any side load into coupler and
also to align pilot diameter of pump to flywheel plate
bore.
2. While maintaining pump alignment with spring cou-
pler and flywheel plate, install two (2) cap screws and
washers to secure piston pump to engine flywheel plate.
Torque screws from 79 to 84 ft−lb (108 to 113 N−m).
3. Install gear pump to piston pump (see Gear Pump
Installation).
4. Position traction rod to control arm on piston pump
by installing cap screw, spacer and lock nut.
5. Connect two (2) wires to neutral switch on traction
pump.
6. Remove plugs or caps from disconnected hydraulic
hoses and open ports of the pump assembly. Install fit-
tings and hoses to correct location on gear and piston
pumps.
7. Install new filter and fill hydraulic reservoir with cor-
rect oil.
8. Disconnect engine run solenoid electrical connector
to prevent engine from starting. Prime pumps by turning
ignition key switch to crank engine for 10 seconds. Re-
peat cranking procedure again.
9. Connect engine run solenoid electrical connector,
start the engine and check for proper operation.
10.Properly fill hydraulic system (see Charge Hydraulic
System in this section).
11. Stop engine and check for hydraulic oil leaks. Check
hydraulic reservoir oil level.
Page 4 − 59 Hydraulic System